Group Delay (Latency); Led Status Indicators - Benchmark ADC1 USB Instruction Manual

Jitter Tolerance (With no Measurable Change in
Performance)
Maximum Amplitude of Jitter Induced Sidebands
Maximum Amplitude of Spurious Tones with 0 dBFS test
signal
Maximum Amplitude of Idle Tones
Maximum Amplitude of AC line related Hum & Noise
Interchannel Differential Phase (Stereo Pair)
Interchannel Differential Phase (Between ADC1 USB
Units)
Maximum Lock Time after Fs change
Mute on Sample Rate Change
Mute on Loss of External Clock
Mute on Lock Error
Mute on Receive Error
Soft Mute Ramp Up/Down Time

Group Delay (Latency)

Delay (Analog Input to Digital Output)

LED Status Indicators

LED Location
Mode Indicators
Meter
ADC1 USB Instruction Manual
>12.75 UI sine, 100 Hz to 10 kHz
> 3.5 UI sine at 20 kHz
> 1.2 UI sine at 40 kHz
> 0.4 UI sine at 80 kHz
> 0.29 UI sine at 90 kHz
> 0.25 UI sine above 160 kHz
< -134 dB (measurement limit) (10
kHz 0 dBFS test tone, 12.75 UI
sinusoidal jitter at 1 kHz)
-130 dBFS
-145 dBFS
-130 dBFS
+/- 0.5 degrees at 20 kHz
+/- 0.5 degrees at 20 kHz
< 1 s for frequency lock
< 5 s for phase lock
Yes
No
No
No
10 ms
1.20 ms at 44.1 kHz
1.09 ms at 48 kHz
0.75 ms at 88.2 kHz
0.67 ms at 96 kHz
0.63 ms at 176.4 kHz
0.59 ms at 192 kHz
Front Panel
9 green
14 green, 2 yellow, 2 red
Page 24