Connection Terminals - NEC NC1040L-A User Manual

1. What's in the Box? and the Names of the Projector Parts
8. Control terminal (CONTROL/SLAVE)
Connect the dedicated interface cable to monitor the status of the laser unit from the projector.
9. Air outlet
The air outlet to exhaust heat inside the laser unit. Do not cover.
10. Optical fiber cable (2 cables)
Connect through optical fiber cable mounting port of the projector. Consult your dealer for installing/removing the optical
fiber cable.
• Do not touch the air outlet when your projector and laser unit are operating. Otherwise, the high temperature
NOTE
may cause burns.
• Do not cover the air inlets while the projector and laser unit are in operation. Insufficient ventilation leads to a
rise of the internal temperature and may cause a fire or malfunction.

1-3-4. Connection terminals

1
GP I/O
PWR
6
7
8
1. External control terminal (GP I/O) (D-Sub 37P)
The terminal for externally controlling the projector or connecting a 3D image system to the projector. (See page 82)
2. 3D terminal (3D) (D-Sub 15P)
The terminal for connecting a 3D image system to the projector. (See page 87)
3. PC control terminal (RS-232) (D-Sub 9P)
The terminal for operating the projector from a PC via an RS-232C or for service personnel to set data for the projector.
Connect the projector and the PC with a commercially available RS-232C straight cable.
4. USB port (USB) (type A)
The port for the projector maintenance.
5. Service terminal (REMOTE) (Stereo mini)
This terminal is used for service purpose only.
6. Device management indicator
The indicator for displaying the projector status. Used by service personnel during maintenance.
7. Slot B
The slot is used for optional boards (page 33). Contact your dealer/distributor for an installation of optional boards.
26
2 3
3D RS-232
PORT
SOFT OS FMT ICP B A
FOR SERVICE
9
4 5
REMOTE
USB
14
10
LAN
11
12
13