Names Of The Projector Parts - NEC NC1040L-A User Manual

1-3. Names of the Projector Parts

1-3-1. Front of the Projector
1
2
1 Air inlet
The air inlet for cooling inside the projector. Do not cover.
An air filter is attached over the air inlet to prevent dust. Refer to "5-3. Replacing the Air Filter" (page 59) on how to replace
the air filter.
2. Optional lens stay fittings
This will be used for function expansion in the future.
3. Handle for transportation
The handle is used when transporting the projector.
4. Lens (optional)
Images are projected from the lens. Request your dealer/distributor to install or replace the lens.
5. Level adjusters (in four positions)
In the ordinary installation, you can adjust the projector inclination at 4 positions.
6. Cooling fluid gauge
The gauge to indicate the remaining amount of the DMD cooling fluid
7. Air Outlet
Exhaust heat in electric circuit section of the projector. Do not cover.
8. Buzzer (inside of projector)
The buzzer rings when the power is turned on or an error has occurred.
• Do not touch the air outlet and backside of the main unit when your projector is operating. Otherwise, the high
NOTE
temperature may cause burns.
• Do not cover the air inlets and outlet while the projector is in operation. Insufficient ventilation leads to a rise of
the internal temperature and may cause a fire or malfunction.
1. What's in the Box? and the Names of the Projector Parts
3
4
2
8
7
6
5
23