Connection Terminals - NEC NC800C User Manual

1-3-3. Connection terminals

1
1. Remote control input terminal (REMOTE IN) (Stereo mini)
Connect the remote control of the projector, using the supplied remote control cable.
Memo
• The projector's remote control can be used by connecting with the remote control cable. (See page 13)
2. PC control signal switch (CINEMA/SYSTEM)
Use this to set data on the projector.
3. PC control terminal (RS-232C) (D-Sub 9P)
This is used when the service personnel sets the data for the projector or operates the projector from PC via RS-232C. Use
a commercially available RS-232C straight cable to connect the projector to the PC.
4. PC card slot
• Set a wireless LAN card, and you can control the projector from a PC, using a wireless LAN Please inquire your dealer/
distributor about a wireless LAN card that can be used.
• Use this slot when doing maintenance on your projector.
5. USB port (USB) (type A)
Use this port when doing maintenance on your projector.
6. HDSDI A input terminal (SDI-A) (BNC)
Connect a Video Server of Video source to this terminal. Use a 75Ω coaxial cable.
7. HDSDI B input terminal (SDI-B) (BNC)
Connect a Video Server or Video source to this terminal. Use a 75Ω coaxial cable.
8. DVI-D A input terminal (DVI-A) (DVI-D 24P)
Connect the DVI-D output terminal of a PC to this terminal. Use a commercially available DVI-D signal cable (Single Link).
1. What's in the Box? and the Names of the Projector Parts
2 3 4
6 7
8
9
10
11 12
5
7