Do you have a question about the 12 LITRE DEHUMIDIFIER and is the answer not in the manual?
Questions and answers
Michael Bromell
May 29, 2025
model number 415/9029 Water tank is empty. Filter is clean.
When the power is on, the green light indicates that it is running.
But it is not running.
1 comments:
Mr. Anderson
May 29, 2025
If the Challenge 12 LITRE DEHUMIDIFIER (model 415/9029) shows a green light but is not running, despite an empty water tank and a clean filter, possible issues include:
1. The room temperature is outside the operating range (below 5°C or above 35°C), which activates the protection device and prevents operation. 2. The unit was restarted too quickly after being turned off. Wait at least 5 minutes before turning it on again to avoid compressor damage.
Check room temperature and ensure proper restart timing.
This answer is automatically generated
michael bromell
May 31, 2025
it has ceased working. power is on, tank is empty, but no sound of motor.
Is it ready for scrap? what would be its modern replacement?
Related Manuals for Challenge 12 LITRE DEHUMIDIFIER
Thank you for selecting super quality dehumidifier. Please be sure to read this manual carefully before using it. Keep the manual for future reference. SAFETY INSTRUCTIONS Please read the operating instructions carefully before using your dehumidifier for the first time. 1.
Page 3
Don’t try to repair, dismantle or remold such appliance, or it may make some damage. Even if the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a similarly qualified person in order to avoid a hazard. PLACEMENT When positioning the dehumidifier, ensure that it is placed on a level surface and that there is a minimum of 10cm of space on either side of the unit to allow for efficient airflow.
KNOW YOUR APPLIANCE MAIN UNIT CONTROL PANEL (1) ON/OFF button (2) Full water indicator Operation Plug the unit into a correct mains socket. Press the “ON/OFF” button once. The unit will start to work and the power indicator light will illuminate. Press the “ON/OFF”...
DRAINAGE While the water tank is full, the compressor will stop and the water full indicator light will illuminate. To remove the water tank, pull it out carefully from the unit. After empting the water tank, place the tank back to the unit. Make sure it is properly positioned, in order for the water full indicator light to go out and your dehumidifier is operating.
Page 6
3. Insert the rubber water stopper to the continuous drainage port. 4. Put the water tank back to the unit. Rubber water stopper Remove the plastic cover and insert the water tube through the hole. Water tube Continuous drainage hole ...
Page 7
CLEANING Always unplug the unit from the power supply before beginning cleaning to avoid electric shocks. Housing - Use a soft, damp cloth to wipe the cabinet clean. Never use strong chemicals, oil-based products, detergents, chemically treated cloths or other cleaning solution. These could damage the cabinet.
STORAGE If not use the unit for an extended period of time. Please: Turn the unit off and unplug it from the mains. Completely empty the water tank and wipe it clean. Cover the unit and store where it will not receive direct sunlight. TROUBLE SHOOTING Never try to repair or dismantle the dehumidifier yourself.
TECHNICAL DATA Model MDF-12DMN3 Mains 220V-240V ~50Hz Power 260W Ampere consumption 1.4 A Dehumidification capacity L/24h 10 L/24h (30℃ RH 80%) Dehumidification capacity L/24h L/24h (32℃ RH 90%) Air volume(max) m³/h m³/h Refrigerant load R134a/130 g Compressor TATUNG FE140Y-E Recommended room size Up to Water tank Dimensions(W*H*D)
Need help?
Do you have a question about the 12 LITRE DEHUMIDIFIER and is the answer not in the manual?
Questions and answers
model number 415/9029 Water tank is empty. Filter is clean. When the power is on, the green light indicates that it is running. But it is not running.
If the Challenge 12 LITRE DEHUMIDIFIER (model 415/9029) shows a green light but is not running, despite an empty water tank and a clean filter, possible issues include:
1. The room temperature is outside the operating range (below 5°C or above 35°C), which activates the protection device and prevents operation.
2. The unit was restarted too quickly after being turned off. Wait at least 5 minutes before turning it on again to avoid compressor damage.
Check room temperature and ensure proper restart timing.
This answer is automatically generated
it has ceased working. power is on, tank is empty, but no sound of motor. Is it ready for scrap? what would be its modern replacement?