Table of Contents
Advertisement
Intercom ID Codes
The Base and Keypad that came in this kit are programmed at the factory to communicate with each
other, and do not need the ID Codes programmed. This Base is the MASTER or #1 unit.
Adding Additional Base Units
If you have purchased additional Base units to
enhance your system, each additional unit's ID
Code must be programmed into the Keypad so
they can communicate. Follow the steps below to
set the ID codes.
Batteries must be installed and the units turned ON.
1. Press and release the "ID SET" button on the Keypad.
2. Press the number on the Keypad that corresponds to
the Intercom you are adding or changing. You will hear
the number of beeps corresponding to the number you
pressed.
For Example: If you are adding a third Intercom to the
system PRESS #3. The Keypad will beep THREE times.
3. Press the "ID SET" button on the Intercom approximate-
ly 2 seconds then release. You will hear THREE beeps
from the Intercom and THREE beeps from the Keypad,
which means the ID Codes are set.
IMPORTANT: Place Intercoms through the home or office
with at least 10 feet between them to prevent interference.
ID SET button
Keypad - Inside
ID SET button
Intercom - Bottom
7
Keypad - Front
Advertisement
Table of Contents
