Mighty Mule F3101MBC Installation Manual

Additional
Intercom Base Unit
Face
Bottom
FCC WARNING: Changes or modifications to this unit not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in particular installations. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following measures: • Reorient or replace the receiver antenna. • Increase
the separation between the equipment and the receiver. • Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected. • Consult the dealer or an experienced radio/TV technician for help.
© 2015 GTO ACCESS SYSTEMS, LLC
POWER Light:
LED is GREEN when charging on AC power source and RED during battery
power mode. Blinking RED indicates low battery on Base unit.
KEYPAD BATTERY INDICATOR Light:
LED turns ON when keypad battery is low.
GRANT ACCESS Button:
The GRANT PERMISSION button must be pressed then
the person at the keypad can press any key to open the gate.
END CALL Button:
Allows user to terminate the call.
9 Vdc Transformer Plug:
Transformer plugs here to charge the base unit battery.

VOLUME Control:

Controls volume level of speaker.
BATTERY ACCESS Cover:
Rechargable 3.6 Volt Ni-MH battery included.
ON/OFF Switch:
Turn OFF to conserver power when battery operated.
ID SET button:
This button is used only when there is another pair of
GTO wireless intercom units nearby causing interference.
PUSH TO ANSWER/TALK Button:
Used to answer CALL from keypad.
HOLD to talk - RELEASE to listen.
F3101MBC
F3101MBC - Instructions - 09/09/15