Id Number And Id Data Setting - Marantz DV12 Service Manual

ID NUMBER AND ID DATA SETTING

Entering the ID Number and ID Data for Players with DVD-Audio Compatibility
It is necessary with a player with DVD-audio compatibility to set an individual number (ID number) and ID data. If the number and data
are not set correctly with the following procedure, operations in the future may not be guaranteed.
Important: Write down the specified ID number by checking it according to "How to confirm the ID number" shown below.
The Input is Necessary When:
• Downloading FLASH-ROM is finished. (The latest version must be downloaded when a repair is made.)
• "No ID Number" is displayed on the screen (TV moniter) or FL display immediately after the power is turned on or in Stop mode .
• If "No ID DATA" is displayed, the ID data must be entered.
Note:
Be sure to enter the ID number in Stop mode.
Use the remote controller RC-12DV(DV-12S1) for operations. Only opening/closing of the tray are performed from the player.
How to Input the ID Number and ID Data (FLASH-ROM)
To enter the input mode, do the following procedure when no ID number is set like just after downloading.
If an ID number has been written to the set, the ID number is memorized in the EEPROM on the front PCB board(PF01)
and no number but the ID number can be input. To write another ID number to the set that an ID number is has already
been written, delete the ID number in both EEPROM and Flash ROM, and input a new ID number.
1 To enter the input mode, operate *A1 in a status with no ID
number set, such as after FLASH-ROM downloading.
Operate *A1(ID number confirmation mode):
1. PAUSE and STOP are pushed simultaneously.
2. 1.2. and 1 are input
3. PLAY is pushed
2 As number input is enabled when the unit enters the input
mode, input the 9-digit ID number.
(The entered number is also displayed on the FL display.)
[Player's ID Number Setting]
ID Number ?
> - - - - - - - - -
2
<CLEAR> Exit
Input ID Number !
3 After inputting the number, press SEARCH to register the ID
number.
[Player's ID Number Setting]
ID Number ?
> 0 0 0 0 0 0 0 0 1 OK ?
<PLAY> Compare Mode
<SEARCH> Enter
3
Input ID Number !
4 When the ID number has been registered, the unit enters the ID
data input mode. (The FL display indicates "NO ID DATA.")
In this condition, place the ID data disc on the tray and close the
tray using the OPEN/CLOSE key on the player.
[Player's ID Data Setting]
<CLEAR> Exit
Insert The ID Data Disc !
4
5 While the data are being read, the message shown in the figure
at left is displayed on the screen.
(The FL display indicates "RD ID DATA.")
[Player's ID Data Setting]
Loading The ID Data Disc !
5
3-23