Page 4
On-Q appearing on the product, will be free from defects in workmanship and materials, under normal use, for (1) one year from the date of original purchase from On-Q or its authorized dealer or installer. The sole obligation of On-Q under this express warranty shall be, at the option and expense of On-Q, to replace the product with a comparable product, or repair the product.
Do not attempt to terminate, change, or un-install any wiring without first the model number and calling your On-Q installer or On-Q Technical Support. If you are not using a 12V power supply that supplies enough current to the system, turning off power at the Intercom Module which is located in the On-Q then the Units may not power on.
Figure 1 - inQuire™ 1000 Intercom System Components • Intercom Module: This module is typically installed in the On-Q enclosure and is considered the "brains" of the system. All Room Units, Door Units, Patio Units and the Main Console Unit are connected directly to the Intercom Module via "home run"...
Pre-Wiring (Rough-In) The following section explains the various functions and operational features of the components of the inQuire 1000™. The rough-in of the inQuire™ 1000 Intercom System should be completed during the construction phase of the home and prior to the installation by the Main Console Unit home builder of any wall covering such as drywall.
Page 11
Insert the Intercom Module into the mounting bracket and insert the door to the room. Verify each Room Unit location with the bracket into the On-Q enclosure. Secure the Intercom Module to the homeowner before proceeding. Avoid installing Room Units in the...
Page 15
Intercom Module and Door Chime between the punchdown insert and the start of the cable insulation The rough-in of the On-Q Enclosure that will house the Intercom Module and Door Chime will need to be completed per the enclosure's installation instructions. There is no further rough-in work required for the Intercom Module and the Door Chime since these components will mount directly in the On-Q Enclosure during trim-out.
Need help?
Do you have a question about the inQuire 1000 and is the answer not in the manual?
Questions and answers