Listing Approvals; Product Dimension Specifications - Desa CEF26-3 Installation Manual

11. Do not insert or allow foreign objects to
enter any ventilation or exhaust opening
as this may cause an electric shock or fire
or damage the heater.
12. To prevent possible fire, do not block air
intakes in any manner. Do not use on soft
surfaces, like a bed, where openings may
become blocked.
13. Always use properly grounded fused and
polarized outlets.
14. A heater has hot and arcing or sparking
parts inside. Do not use it in areas where
gasoline, paint or flammable liquids or
vapors are used or stored.
15. Use this heater only as described in this
manual. Any other use not recommended
by the manufacturer may cause fire, elec-
tric shock or injury to persons.
16. Avoid the use of an extension cord be-
cause the extension cord may overheat
This heater has been tested in accordance
with the CSA Standards for fixed and location-
dedicated electric room heaters in the United
States. All components are UL or CSA safety
certified.
If you need assistance during installation,
please contact your local dealer or the DESA
Heating, LLC at 1-866-672-6040.

PRODUCT DIMENSION SPECIFICATIONS

120927-37C
SAFETY
Continued

LISTINg APPROvALS

26.125"
26.0"
17.50"
Figure 1 - Heater Dimensions
28.125"
www.desatech.com
and cause a risk of fire. However, if you
have to use an extension cord, the cord
should be No. 14 AWG minimum size and
rated not less than 1875 WATTS.
17. Always use ground fault protection where
required by electrical codes.
18. Always disconnect power before perform-
ing any cleaning, maintenance or reloca-
tion of heater.
19. To prevent a possible fire, do not burn
wood or other materials in this heater.
20. To prevent electric shock or fire, always
use a certified electrician should new
circuits or outlets be required.
21. When transporting or storing heater, keep
in a dry place.
22. Louvers get hot during operation. Open
louver door using 2 hands at outer edges
of door. Do not open in center.
26.125"
Description:
Voltage:
Watts:
Amps: 15 Amp Grounded Circuit
Note: This heater must be electrically wired and
grounded in accordance with local codes or, in
26.0"
the absence of local codes, with National Electric
17.50"
Code ANSI/NFPA 70-latest edition or the Cana-
dian Electric Code, CSA C22.1 as appropriate.
28.125"
Shown with optional trim BAFT-2. See
Accessory, page 12, for other trim options
26" Fireplace/Insert
120
1500
3