Controller Layer; Program Mode - WowWee Roboreptile User Manual

COntrOLLEr LayEr 

GREEN ANIMATED LIGHT
Stop
Forward
Sweep
Left Tail Strike
Right Tail Strike
Attack
Shake
Dizzy
Bite
Feed
To stop Roboreptile from performing his current action press Stop.
Press to make Roboreptile perform jumps. Press again to toggle between 2 styles.
See Jump on p.11
Press to make Roboreptile perform a sweep.
Press to make Roboreptile perform a left tail strike.
Press to make Roboreptile perform a right tail strike.
Press to make Roboreptile attack.
Press to make Roboreptile shake.
Press to make Roboreptile dizzy.
Press to make Roboreptile bite.
Press and hold Feed for Roboreptile feeding interaction (see p.7)


prOgraM MOdE

A 20-step program can be made using the Direction and
Animation buttons.
To ENTER Program Mode press the Program Button. Roboreptile will
get up on his back legs and will not move once in Program Mode.
Clearing the Program
IMPORTANT
By entering Program Mode, any programs will be immediately cleared.
Pressing Program Play immediately after entering Program Mode
will leave the program clear, as will leaving Roboreptile without
entering any program steps.
Programming your Roboreptile
Choose a combination of controller commands from all three
layers of the controller to form a program.
There are 20 steps in each program. When a step is successfully
entered, a confirmation will be sounded. When Roboreptile is
unable to perform a step, a denial will be sounded.
Roboreptile cannot be programmed with the following steps:
– Demo Modes
– Guard Mode
– Volume Control
– Feed
– Stop
Exiting Program mode
To exit Program Mode immediately, press Program Play.
Roboreptile will perform a program if one is stored.
To exit Program Mode, the user can leave Roboreptile
for approximately 30 seconds
Without inputting any commands, Roboreptile will enter
Free Roam Mode after 30 seconds. If commands have been
inputted, Roboreptile will perform the routine.
NOTE
Pressing STOP will be considered as a command input and will not exit Roboreptile from
Program Mode. Stop does not register as a programmable command in Program Mode.
Playing the Program
The user can replay the program at any time by pressing
the Program Play button.
NOTES
Guard Mode, Volume control and Demo Modes will not register while Roboreptile
is in Program Mode and cannot be entered as a step in a program.
Pressing the Feed button will not register as a step in the programming of Roboreptile,
but will interupt Program Mode. Roboreptile will start his Feed routine.
The program memory is cleared when Roboreptile is turned off.