Lighting The Water Heater - Solahart Streamline Gas Owner's Manual

LIGHTING THE WATER HEATER

FOR YOUR SAFETY READ BEFORE LIGHTING
Warning: This gas water heater is designed to operate reliably and safely as long as the operating
instructions are followed exactly. You must comply with these lighting instructions at every stage.
Make sure the water heater is filled with water and the water supply is on, otherwise serious
damage to the vitreous enamel cylinder lining and plastic components may occur.
The installer must check all gas connections for leaks, gas supply pressure and test point pressure
(refer rating label). Remove the access cover at the front of the water heater to access the gas
thermostat.
Note: The main burner will only light when the word "ON" appears on the timer.
SAFETY INFORMATION
A. This water heater is equipped with an igniter button which lights the pilot. When lighting the pilot
follow these instructions exactly.
B. Before lighting ensure there is no smell of gas around or in the vicinity of the water heater and
the burner opening. Be sure to smell next to ground level as some gases can settle there.
C. What to do if you smell gas.
Do not try to light the water heater.
If the gas smell is throughout the area, turn the gas control knob clockwise to the " " (off) position
and then turn off the isolation valve on the gas line to the water heater. Leave the area and call
your nearest Solahart Dealer or a qualified service technician.
D. Use only your hand to turn the gas control knob, never use tools. If the control knob will not turn
by hand, don't try to repair it, call a qualified service technician. Force or attempted repair may
cause a fire or explosion.
E. Do not attempt to operate this water heater if it has been damaged. Call a qualified service
technician.
38