Table of Contents
Advertisement
Enrolling the Garage Door Controller
Before the system can be used, the ADT Pulse system needs to enroll the Garage Door
Controller. Bring the Controller near your ADT Pulse Gateway and apply power to the
Garage Door Controller.
✓ NOTE: Before enrolling device to any Z-Wave network, or after removing it from any Z-Wave
network, it is recommended that the Controller be factory reset. Reset the Controller by
pressing the Include button 5 times.(Location of Include button is shown in Figure 2 on
Page 3). A quick beep followed by a longer beep will indicate proper reset of the GD00Z-2.
To add a Garage Door Controller:
1. Open your Web browser and in the address bar enter:
2. Enter your Username and Password, then click the Sign In button.
3. Click the System tab, then click the Manage Devices button. The Manage Devices
Assistant appears.
Enrolling with the System
https://portal.adtpulse.com
5
Hide quick links:
Advertisement
Table of Contents
