Product Description; Overview - Linear ADT Pulse GD00Z-2 Installation Instructions Manual

Product Description

Overview

◆ Replication is the process of copying or transferring your Z-Wave network from one
controller to another.
◆ This is a Security enabled Z-Wave product and must be used with a Security enabled
Z-Wave controller in order to fully utilize this product. As such, this device will not respond
to Basic CC commands.
◆ The GD00Z-2 is a garage door opener remote command transceiver with built-in Z-Wave®
technology.
◆ Allows remote operation of a garage door opener using the ADT Pulse touch screen, web
portal, or mobile app.
◆ Z-Wave is an Interoperable two-way RF mesh networking technology designed for use with
a Z-Wave gateway/controller and other Z-Wave enabled devices.
◆ Acts as a Z-Wave repeater to improve communications within the Z-Wave mesh network.
◆ ASSOCIATION: The GD00Z-2 supports 1 Group with 1 Node. Group 1 must be assigned the
Node ID of the controller to which unsolicited notifi cations from the Controller will be sent.
The ADT Pulse should set this association automatically after inclusion.
Summary of Operation
◆ Controller connects to the garage door opener's pushbutton wall console terminals.
◆ A wireless tilt sensor mounts on the garage door and reports the door's position to the
Controller.
◆ GD00Z-2 responds to Z-Wave commands from ADT Pulse to open or close the garage door.
◆ A warning indicator light fl ashes and a beeper sounds for 5 seconds before the door begins
to move.
◆ If the door does not completely open or close, a second open or close command can be sent
after 30 seconds.
◆ If the door does not completely open or close after the second attempt, the Controller
operation is suspended until a local garage door pushbutton is activated.
THE TILT SENSOR SENDS DOOR
OPEN OR CLOSED STATUS TO THE
GARAGE DOOR CONTROLLER
2
THE GARAGE DOOR CONTROLLER
SENDS THE DOOR STATUS TO THE
ADT PULSE SYSTEM
Figure 1. System Overview
®
THE ADT PULSE SYSTEM
DISPLAYS THE DOOR STATUS
THE ADT PULSE SYSTEM
COMMANDS THE GARAGE DOOR
CONTROLLER TO OPEN
OR CLOSE THE DOOR