Table of Contents
Advertisement
Videoswitch
2 Installation
2.1
Connecting Up (4 Camera example)
101
75 Ohms
IN
100
Make these Connections...
Connect the video input of the Monitor to the main monitor output of the VDM using a BNC cable
100
Make sure that the monitor termination is switched on (i.e. to 75 Ohms)
101
Connect the first camera to Camera Input 1 on the VDM using a BNC cable
102
Connect the next camera to Camera Input 2 on the VDM using a BNC cable
103
Connect the next camera to Camera Input 3 on the VDM using a BNC cable
104
Connect the next camera to Camera Input 4 on the VDM using a BNC cable
105
Make sure that the voltage select switch is set to suit the mains supply voltage prior to applying power
106
otherwise damage may occur. The setting required in UK and Europe is 230Vac.
Connect the mains power using the IEC cable supplied using an IEC to 13A plug cable (provided)
107
When power is applied, the system will perform a self-test and display some system information on the
screen such as the serial number and firmware and hardware revision of the unit. Press any key while this
information is being display to keep it on the screen for longer.
Vdm601r.doc
102
103
VDM Digital Recorder
104
105
106
107
10
Advertisement
Table of Contents
