Hardware Installation - Ubiquiti airMAX Titanium Sector AM-V2G-Ti Quick Start Manual
Mid-gain advanced rf isolation variable beamwidth antenna
Hide thumbs
Also See for airMAX Titanium Sector AM-V2G-Ti:
- Quick start manual (21 pages) ,
- Quick start manual (21 pages)
Table of Contents
Advertisement
Hardware Installation
1. Set the desired beamwidth by adjusting the Beamwidth
Deflectors. Loosen the four hex head screws enough
to move the Beamwidth Deflectors, but do not remove
the screws.
2. Carefully move the Beamwidth Deflectors to the desired
angle, as indicated by the screw slots.
Important:
angle.
3. Tighten the four hex head screws.
Both deflectors must be set to the same
120° Beamwidth
90° Beamwidth
60° Beamwidth
Advertisement
Table of Contents
