Tap Tempo Delay - Medeli FD900 Owner's Manual

Advanced Use
battery, press and hold the FOOT SWITCH firmly,
then plug INPUT and keep holding the FOOT
SWITCH until the ON/OFF LED indicator flashes
three times).
To set MODE 1 back, do the same operation.
Notice:
BYPASS Pan Mode setting will be saved after
power off.

Tap Tempo Delay

The pedal offers a tap tempo function which can
make practice or live performance more
convenient. To use this function, please follow
these steps below:
When BYPASS, and DELAY MODE point to any
mode except S and M, press and hold the FOOT
SWITCH for 2 seconds, at the time, LED begin to
flash, imply entering the tap tempo delay function,
then you can release the FOOT SWITCH.
After entry, press FOOT SWITCH twice or more to
set the DELAY TIME, the interval is just the right
time. Then LED will flash in step with the time to
show the tempo. To set another DELAY TIME,
repeat the operation above.
20
aw_FD900_Manual_G07_101105
2010 11 5 16:54:19
Notice：
DELAY TIME knob is inactivated when using
tap tempo delay. When entering tap tempo
function, the delay time will be the same as the
value of current DELAY TIME knob's position.
To quit tap tempo delay function, press and
hold FOOT SWITCH for 2 seconds, or turn
DELAY MODE to other position.
If the interval between pressing FOOT SWITCH
twice is shorter than the minimal DELAY TIME
of the current mode, the setting is just the
minimal DELAY TIME of this mode; If longer,
tap tempo will keep the current tempo and take
count of a new round.
Notice：
When in different Delay Modes, the time range
of tap tempo function is the same as this Delay
Mode's time range. For example, when using
tap tempo in Analog Delay Mode, the delay
time you can set by "Tap" is from
10ms~1000ms, the same as the original range.
100
95
75
25
5
0