Lehle P-Split Ii As A Recording Splitter - Lehle P-Split II Operating Instructions Manual

What to do:
1. Connect the signal source to the input (1) of the
Lehle P-Split II.
2. Do not use the DIR socket (2).
3. Connect the ISO socket (5) to the signal input.
4. Use the ground lift switch to determine which
position eliminates the most background noise.
5. There you go!
Note:
In the above scenario, the Lehle P-Split II is
grounded via the signal source input. In some cas-
es, it may be a good idea to connect the ground
to the other side, in order to eliminate even more
interference. To do this, simply swap the input (1)
and the ISO output (5).
The Lehle P-Split II as a recording splitter
It can be very useful, when recording guitar or
bass, to record not only the amplified signal, but
also the dry (unprocessed) signal. This signal can
then be routed in the mix either to a real ampli-
13