Lehle P-Split II Operating Instructions Manual page 11

The ISO output has an input signal which is
isolated by means of the Lehle LTHZ high-end
transformer. A balanced or an unbalanced signal
is possible, irrespective of the type of signal fed
from the input.
6. Base and fixing
 You can use the fixing screws supplied with the
Lehle P-Split II to fix it to a base plate (or
to a pedal board, for example).
Tip: in case you prefer a velcro solution for your
pedalboard we recommend to write down the
serial number of the pedal before covering it for
eventual support matters.
Thanks to its ready-to-go fixing system, the Lehle
P-Split II can be mounted without difficulty
on a base plate. To do this, undo the four housing
screws and detach the cover. Then fix the device
base to a base plate using the two screws, the
washers and the spacers supplied. Replace the
cover and tighten the four housing screws - done!
9