Lehle P-Split Ii As A Compact Passive Di Box - Lehle P-Split II Operating Instructions Manual

The Lehle P-Split II as a compact passive
DI box
The Lehle P-Split II can be used as a passive
DI box. Balanced or unbalanced signals from the
ISO output can be fed. A TRS/XLR adapter will be
needed if you want a balanced signal for an XLR
input (please also see "Balanced signal lines" on
page 4).
Device connection
Input (1)  Instrument (active)
DIR output (2)  Amp
ISO output (5)  Input mixer, stage box
How to do this:
1. Connect your instrument or the output from a
preamp or buffer to the input (1) of the Lehle
P-Split II.
2. Connect your amp to the DIR output socket (2).
3. Connect the ISO socket (5) to the input of your
mixer or stage box.
4. Actuate the phase switch to find out which set-
ting sounds better to you.
5. Use the ground lift switch to determine which
position eliminates the most background noise.
6. There you go!
Note:
The signal from a passive pickup cannot be split
to an amp or mixer without negative effects on
11