Table of Contents
Advertisement
Command 47
Off-Set time
After the Control Panel's power is supplied,
the time of the Check-in Report starts
calculating.
According to the setting of Off-Set time,
the Control Panel will send Check-in
Report once, and then send report
according to the setting of Command 43
－ Test call.
Function Selection
(1)
(2)
(3)
(4)
(5)
(6)
Factory default is set as (1) 1 Hour. When
the Off-Set time is reset in programming
Mode, the time of the Off-Set period will
recalculate.
Off-Set time Report will be sent only once,
and then the Control Panel sends Check-in
Report according to setting of period test
call, unless the Control Panel restarts or
the Off-Set time is reset.
Command 49
Supervision
This option is used to enable system
supervision
function.
IC2020 will be able to receive the check-in
signals from Wrist Pendants (WTR-) to
indicate their proper functioning.
Function
Selection
(0)
(1)
(2)
(3)
(4)
(5)
(6)
Result
1 Hour
2 Hours
3 Hours
4 Hours
8 Hours
12 Hours
Once
enabled,
Result
Disable
4 Days
5 Days
6 Days
7 Days
8 Days
9 Days
17
Factory Default is set as (4), 4 Days.
When the supervisory timer expires and no
supervision signal is received from WTR-,
the supervisory alarm reporting will be
made.
The reporting for supervisory alarm is
status reporting (Contact ID 147, Scancon
515555559, or Tunstall D#1013). The
report will be sent based on your reporting
methods without Guard Time waiting and
Follow-On.
Command 50
Record Message
To record a voice message:
Step 1: Enter 50#. A long beep will be
heard both via the phone set and
IC2020, indicating it is ready to
record your message.
Step 2: Please
microphone on IC2020 to record
your message. A maximum of 20
seconds is allowed.
: P
Step 3
ress # key to end the recording
before the time is up. Two beeps
will be heard both via the phone
set and IC2020, indicating the
recording is completed or the time
is up.
<
N
O
T
E
>
<
N
O
T
E
>
Message can only be recoreded locally
alongside
IC2020
Microphone.
Please use command #51 to check the
recorded message.
To re-record, please repeat Steps 1-4 to
overwrite the message.
Command 51
Play Message
This function plays the recorded message
by Command 50.
If the recorded message is shorter than the
maximum recording time, message played
will be shortened accordingly.
speak
toward
via
the
bulilt-in
the
Advertisement
Table of Contents
