Table of Contents
Advertisement
Command 41
Auto Answer for Remote Programming
IC2020 can be programmed to auto answer
incoming phone calls after a pre-set
number of rings have been reached. The
number of rings ranges from (00) (no auto
answer) to (32) rings.
Function Selection
(00)
(01) - (32)
Factory Default is as (20) Rings.
<
<
N
N
O
O
T
T
E
E
>
>
If 00 is selected, it means the IC2020
cannot auto-answer the call by ring
count. If you want to do Remote
programming,
Remote
described under System Conifuration,
I. Entering Programming Mode: 2.
Remote Programming Mode.
Command 42
Guard Time Delay
IC2020 can be programmed to delay alarm
reporting from (00) (instant reporting) to
(99) seconds.
During this time period, a voice prompt "Bi-
Bi-Bi Emergency", will be played twice to
alert user at a rate of approximately once
per 3 sec.
If a false alarm is triggered, it can be
cancelled within the Guard Time Delay.
Function
Selection
(00)
INSTANT REPORTING
(01) - (99)
Factory Default is set as (05), 5 SEC.
<
N
O
T
E
>
<
N
O
T
E
>
The Emergency alarm cannot be
Result
OFF
ON
please
follow
Programming
method
Result
DELAY
cancelled after the Guard Time is
elapsed.
Command 43
Periodic Test Call
IC2020 can be programmed to make test
calls periodically from (00) (no test call) to
every (1) - (7) or 30 days:
Function Selection
(1) - (7)
Factory Default is set as (5), 5 DAYS.
the
Command 44
Mobility Timer
This function monitors user movement around
the premises and sends an inactivity report to
the Monitoring Center if the user fails to reset
the inactivity timer.
This will disable or enable the Inactivity
Timer with selectable count down periods.
Options are:
Function
Selection
Factory Default is set as (0), DISABLE.
<
N
O
T
E
>
<
N
O
T
E
>
The Mobility Timer counting down can
be reset by:
1.
2.
15
Result
(0)
OFF
1 - 7 DAYS
(8)
30 DAYS
Result
(0)
DISABLE
(1)
12HR
(2)
24HR
Pressing the NURSE button on
IC2020, or,
Movement
detected
Detector
by
PIR
Advertisement
Table of Contents
