Gardsman CTC-1132 Installation & Operating Manual page 43

< N O T E >
< N O T E >
To receive fault status by SMS, the
first telephone number must be set as
SMS Report. (refer 2.2.1 Telephone
Numbers)
AC Power Fail
The yellow LED will light and the
fault message will be displayed.
In addition, the panel will report the
fault event by SMS to the first
telephone number in all modes.
Once AC Power is restored, the
panel also will report the restore
event by SMS to the first telephone
number.
Control Panel Low Battery
Any time the Panel battery Low is
detected, yellow LED will light while
this fault message can be viewed
on LCD under Fault Display.
Sensor Low Battery
If the low battery is detected on any
sensor, yellow LED will light up at
any time while its fault message
can be viewed on LCD under Fault
Display.
Panel Sabotaged
If the Tamper switch on the Control
Panel is triggered, yellow LED will
light. User can check the fault
message
Display in user menu.
In addition, the panel will report the
fault event by SMS to the first
telephone number in all modes.
Sensor Sabotaged
If the Tamper switch on the PIR
Sensor, Door Contact, Remote
Keypad, or Bell Box (BX-8) is
triggered, yellow LED will light.
User can check the fault message
in selection Fault Display in user
menu.
In addition, the panel will report the
fault event by SMS to the first
telephone number in all modes.
in selection Fault
< N O T E >
< N O T E >
The siren will sound alarm for tamper-
trigger depends on the Tamper Alarm
setting (refer 2.4.12 Tamper Alarm).
Sensor out-of-order
When the control panel has not
received the supervisory signal
from each individual PIR sensor,
Door Contact or Smoke Sensor, etc.
for a period (according to the
setting of the Supervision), the
yellow LED on the panel will light
while this fault message can be
viewed
Display. No alarm event will be
reported while the system is in all
modes.
Interference
When the system is programmed
with Interference Detection On, and
when there is an interference
detected for 30 seconds, the yellow
LED will light up and the fault
message can be viewed under the
Fault Display.
38
on LCD under Fault