Table of Contents
Advertisement
P l e a s e
o n e
The message will be displayed for 2
sec. then the screen returns to Device
+/- menu. You are requested to add a
detector or Remote Controller first
then you can try programming these
auxiliary devices again.
<
I
M
P
O
R
T
A
N
T
N
O
<
I
M
P
O
R
T
A
N
T
N
O
For the following options, whichever option
is selected, when the Control Panel
transmits the signal, all added sirens will
simultaneously received the signal and all
will acted accordingly
Siren Tamp.On, Siren Tamp.Off
The Outdoor Siren BX-8 tamper switch can
be enabled and disabled remotely. This is
used especially when replacing siren
battery.
Disable the Siren tamper switch by
selecting Siren Tamp.Off and press
OK key.
temporarity
Protection simultanously
Enable the Siren tamper switch by
selecting Siren Tamp.On and press
OK key. All added sirens will be
enabled with the Tamper protection
simultanously.
<
N
O
T
E
>
<
N
O
T
E
>
The
Siren
automatically revert to On after about
an hour if not switched back.
Confirm On, Confirm Off
Both the Outdoor Siren BX-8 can be
enabled
for
confirmation where beeps are emitted
from the Siren to validate that the system
has been armed and disarmed.
Disable the Siren Confirmation by
selecting Confirmation Off and press
OK key.
Enable the Siren Confirmation by
selecting Confirmation On and press
OK key.
a d d
d e v i c e
T
E
>
T
E
>
All added sirens will
lose
their
Tamper
tamper
disable
arming
and
disarming
Entry Snd On, Entry Snd Off
The Outdoor Siren BX-8 can be enabled
or disabled from sounding the Entry Delay
warning beeps.
Disable the Siren Entry Sound by
selecting Entry Snd Off and press
OK key.
Enable the Siren Entry Sound by
selecting Entry Snd On and press OK
key.
Receiver 1, Receiver 2
2 additional Universal Receivers can be
added to the system.
Step 1. Put Universal Receivers into learn
mode
Operational Manual).
Step 2. Move the cursor to the position
Receiver 1
Step 3. Press OK key.
Step 4. The Control Panel will then sound a
long beep and transmit Learning code
to UR#1 simultaneously.
status LED lights up for 3 seconds.
<
N
O
T
E
>
<
N
O
T
E
>
If Receiver 2 is also to be added to the
system, proceed to the following steps:
Step 5. Move the cursor to the position
Receiver 2.
will
Step 6. Press OK key.
Step 7. The Control Panel will then sound a
long beep and transmit Learning code
to UR#2 simultaneously.
status LED lights up for 3 seconds.
Step 8. Remember to put these Universal
Receivers out of Learn mode. Adding
them into the system is completed.
24
(Refer
to
their
individual
The UR
The UR
Hide quick links:
Advertisement
Table of Contents
