Kenwood LZH-100W Instruction Manual page 30

Troubleshooting
TROUBLE
No Power
No Picture
Stopped picture
The playback picture is poor.
No color
The remote control doesn't
work properly.
'ERROR-DISC' is displayed on the
screen.
'ERROR-DISC Check Regional
Code' is displayed on the screen.
No function with the remote
control
Unable to insert Disc
No function with all buttons on
the unit & remote control
Check Point
..
..
.. ..
..
..
..
..
..
..
CORRECTIVE AalON
Check that DC power cable is connected properly
1. Make sure that the equipment is connected properly.
2. Check that the connected monitor is turned on .
1. Check that the video cable is connected.
2. Check that the monitor is turned on .
Clean the disc.
Adjust the video system by changing
TV
output mode
(AUTO, PAL, NTSC) ..
Dc
Refer to Page 19(Display Setting)
Remove any obstacles between the remote controller
and remote control sensor of the unit. Operate the
remote control at a closer distance to the unit.
1. Turn the power off, then turn it on.
2. Turn the power off, disconnect the power plug, then
reconnect it.
Check in which region the DVD Disc can be played.
The DVD Disc is not available if the region code of the
DVD Disc is not in conformity to the one of the unit.
;;.'T
Refer to Page
5
(Region codes in the world)
Check the batteries and make sure that the batteries
are fresh
&
new, or have enough battery life.
1. Check if the protection screw was removed before
installation of the unit.
(Only at the first insertion after installation.)
2.
Pullout Disc and wait for
3
seconds, and insert Disc again.
Press the Hard Reset Key,
o.i.;-
Refer to Page 9 (Name & function of each Part)
When a disc is brought from a cold environment to a hot one, there may be steam on the face of the
disc, or water will appear on the pickup lens. It will affect the play.
1. Remove the disc from the DVD player.
2. Turn on the power and leave it on for an hour to vaporise the condensation.
Changing the Dome Lamp
Bulbs
1. Use a screwdriver to pry the dome lamp cover off.
2. Remove the burned-out bulb.
3. Replace the bulb with a 3-Watt(12V) Type T-8 Wedge bulb.(<j>8.5X29mm(Length»
4. Snap the dome lamp cover back on.