Kenwood LZH-100W Instruction Manual page 3

.A.
Warning
A
CAUTION
Use of controls, adjustments or performance of
procedures other than those specified herein may
result in hazardous radiation exposure.
A
Warning
Kenwood Corporation
2967-3, ISHIKAWA-MACHI
HACHIOJI-SHI, TOKYO, JAPAN
Kenwood Corp. CERTIFIES THIS EQUIPMENT
CONFORMS TO DHHS REGULATIONS NO.21 CFR.
1040.10. CHAPTER 1, SUBCHAPTER J.
Location: Bottom Panel
-To minimize the risk of improper installation, Kenwood recommends that the installation of this product be
performed by an MECP-Certified professional installer.
Improper installation may cause damage to the vehicle or injury to the driver and occupants.
-Installation must be performed according to this product installation manual. Kenwood is not responsible for
damages or injuries resulting from installation not performed strictly in accordance with the procedures described
in this manual.
- Proper installation of this product may require the use of mounting hardware not included with this product.
- Use only new, unused and properly-sized fasteners to install this product. Do not use previously-installed or worn
fasteners.
- No modifications to the product or mounting hardware are permitted.
-This product is designed to be used and viewed by rear seat passengers only. The monitor screen must not be
visible to the driver. Viewing by the driver while operating the vehicle will create an unsafe condition.
- Kenwood does not recommend connecting hanging wires or cables to auxiliary connectors while the vehicle is
in motion.
-This product must not obstruct the driver's rear view when installed or used.
-It is the responsibility of the purchaser and installer to comply with all applicable laws and regulations governing
the installation and use of this product.
- Kenwood disclaims all liability for any property damage or personal injury that may result from improper or
unintended installation or use of this product.
FCC WARNING
This equipment may generate or use radio frequency energy. Changes or modifications to this equipment may
cause harmful interference unless the modifications are expressly approved in the instruction manual. The user
could lose the authority to operate this equipment if an unauthorized change or modification is made.
NOTE
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment may cause harmful interference to radio communications if it is not installed and used in accordance
with the instructions. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radiofTV technician for help.
English
3t