Table of Contents
Advertisement
5. Connect the wiring harness (according to the diagram under "Connection diagram" on page 29) to the
wires located in the dome light of your vehicle.
*
Special Tip
Use the provided cable tie to fasten
the Cables from the unit.
6. Open the left/right dome Lamp covers carefully and flip the monitor screen down, and you can find the
screw holes inside dome Lamp covers and on the main body of unit.
Screw the main unit to the support bracket by using the supplied screws.
After installation, Please make sure to place the lamp covers back to the unit.
-
- -
-
~-
~
,
'" Notice
Use only the
supplied
screws in
this shape.
*
Special Tip
Regarding to Trim Ring, a user can choose either of the
below installation methods.
Case A. Installation with Bracket only
Case B. Installation with Bracket and Trim Ring. (Using Trim Ring recommended)
_28
English
Advertisement
Table of Contents
