First Light TOMAHAWK NV Instructions For Use

TOMAHAWK NV (Night Vision) TACTICAL LIGHT INSTRUCTIONS
Thank you for purchasing the Tomahawk NV Tactical Light. We are con-
fident that your new Tomahawk will provide you many years of exception-
al lighting performance. Please carefully review this manual prior to use.
IMPORTANT – PLEASE READ FIRST
• This product should not be operated by anyone who has not
reviewed this manual. Not for use by children.
• The intense white light emitted by the LED may cause momentary
blinding, regardless of the brightness level used. Use caution during
operation; do not point light directly into eyes at any distance.
LITHIUM BATTERY WARNING
Always use standard CR123 Lithium batteries with this product.
Lithium batteries can be dangerous if used improperly. Never disassem-
ble, short circuit, recharge or expose to water, fire or high temperatures.
Never use batteries of different ages, capacities or brands together. Store
separately and properly dispose after use. Keep away from children.
CONTROL
PANEL
BEZEL
BATTERY INSTALLATION
STEP 1. Hold on to the padded battery housing sleeve with one hand and
rotate the battery cap counterclockwise to remove. Insert two batteries "+"
terminals first (towards lamp housing).
STEP 2. Reattach battery cap by rotating it clockwise. Hand-tighten until
snug.
STEP 3. Ensure batteries are properly installed by depressing any
button on control panel; the red LED "lock" indicator should
illuminate. If it does not, repeat Steps 1&2, ensuring both "+" terminals
are facing up.
LAMP HOUSING
MOLLE-READY
RETENTION
CLIP
(ADJUSTABLE)
FINGER LOOP
PADDED
BATTERY
SLEEVE
BATTERY
CAP
LOCKOUT MODE
Lockout Mode prevents accidental illumination. To go from Lockout to
Ready Mode, depress the Constant-On and Cycle Controls simultane-
ously. The green "unlock" indicator will illuminate.
To enter Lockout Mode, depress and hold the Constant-On and Cycle
Controls simultaneously for 1.5 seconds. The red "lock" indicator will illu-
minate.
NOTE: Always put light in Lockout Mode when not in use or
during transport.
FINGER LOOP INSTALLATION/ADJUSTMENT
Your Tomahawk comes with a large Finger Loop installed. To adjust the
position of the Finger Loop, hold the lamp housing in place with one hand,
then rotate the battery housing by turning the padded battery housing
sleeve counterclockwise. Loosen the battery housing to the point at which
the Finger Loop can be rotated to the desired position. Retighten the
Finger Loop by rotating the battery housing clockwise. Make sure that the
battery housing is firmly tightened to lock the Finger Loop in place.
To remove the Finger Loop, loosen the battery housing to the point at
which the Finger Loop can be removed from the groove located at the top
of the battery housing. To reinstall, push the top tab of the Finger Loop
into the groove and retighten the battery housing.
CONTROL PANEL OPERATION
MOMENTARY
CONTROL
CYCLE CONTROL
CONSTANT-ON
CONTROL
LOCK (RED/GREEN)
INDICATOR