Securing Devices; Using The Tripod - Silvercrest SDS 3000 A1 Operating Instructions Manual

Securing devices

GB
IE

Using the tripod

6
NOTICE
► This tripod is equipped with a quick release plate
screwed onto the quick release plate 2 you can, by sliding the locking
device 8 on the side of the tripod plate 3, loosen the device together
with the quick release plate 2 from the tripod plate 3. Thus, you do not
always have to unscrew the device from the thread 1.
1) Remove the quick release plate
device 8 to the side so that you can lift the quick release plate 2.
2) Screw the required device onto the quick release plate
the screw - with the help of the handle on the underside of the quick release
plate 2 - until the device is fi rmly seated.
3) To replace the quick release plate
the tripod plate 3, slide the locking device 8 to the side and reposition
the quick release plate 2. Then secure the locking device 8, such that the
quick release plate 2 is fi rmly seated.
When you have set the tripod up and the device is mounted on it, you can then
adjust it as follows:
■ Loosen the locking screw "High"
turned easily. Turn the crank q to adjust the height. When the desired height
has been reached, fi rmly retighten the locking screw "High" 7.
NOTICE
► Always hold the grip
7 and turn the crank q. Otherwise – if the locking screw "High" 7 is
loosened and the crank q is not fi rmly held - the rod with the attached
device could fall down to the lowest setting and, through it, the device
could be damaged.
■ To swivel the device horizontally through up to 360°, loosen the locking
screw "360°" 5. Take hold of the grip 0 and swivel the tripod plate 3.
When you have reached the desired position, retighten the locking screw
"360°" 5 fi rmly.
■ To adjust the tilt angle, rotate the grip
When the desired tilt angle has been reached, rotate the grip 0 again until
it is fi rm.
2 from the tripod. For this, slide the locking
2 complete with the device back on
7 to a point where the crank q can be
0 fi rmly when you loosen the locking screw "High"
0 and move it either up or down.
2. When a device is
2. To do this, turn
SDS 3000 A1