Table of Contents
Advertisement
2-32
Keys and doors/Alarm system
system will automatically arm and doors
will automatically lock.
Disarming the system
Perform either of the following procedures.
. Briefly press the disarm button (for less
than 2 seconds) on the access key/remote
transmitter.
. Carry the access key and perform
either of the following procedures (models
with keyless access with push-button
start system ).
Grip the front door handle.
Press the rear gate opener button
(5-door).
The following door(s) will unlock, an
electronic chirp will sound twice and the
hazard warning flashers will flash twice.
. Driver s door: when either of the
following procedures is performed
Press the disarm button on the
access key/remote transmitter briefly
(for less than 2 seconds).
Grip the driver s door handle (mod-
els with keyless access with push-
button start system ).
. Rear gate (5-door): when pressing the
rear gate opener button (models with
keyless access with push-button start
system )
. All doors: when gripping the front
passenger s door handle (models with
keyless access with push-button start
system )
The flashing of the security indicator light
will then change slowly (once approxi-
mately every 3 seconds from twice ap-
proximately every 2 seconds), indicating
that the alarm system has been disarmed.
To unlock all other doors and the rear gate
(5-door), briefly press the disarm button a
second time within 5 seconds.
Emergency disarming
If you cannot disarm the system using the
access key/transmitter (i.e. the transmitter
is lost, broken or the transmitter battery is
too weak), you can disarm the system
without using the access key/remote
transmitter.
The system can be disarmed if you turn
the ignition switch from the LOCK (off) to
the ON position with a registered key/
access key.
NOTE
For models with keyless access with
push-button start system , if the ac-
cess key battery is discharged, perform
the procedure described in Switching
power
9-18. In such a case, replace
the battery immediately. Refer to Re-
placing battery of access key
Valet mode
When you choose the valet mode, the
alarm system does not operate. In valet
mode, the remote transmitter is used only
for locking and unlocking the doors and
rear gate (5-door) and panic activation.
To enter the valet mode, change the
setting of your vehicle s alarm system for
deactivation mode. Refer to Activating
and deactivating the alarm system
28. The security indicator light will con-
tinue to flash once every 3 seconds
indicating that the system is in the valet
mode.
To exit valet mode, change the setting of
your vehicle s alarm system for activation
mode. Refer to Activating and deactivat-
ing the alarm system
2-28.
Passive arming (models
without keyless access with
push-button start system )
Passive arming mode
When passive arming mode has been
programmed by the dealer, arming of the
system is automatically accomplished
without using the remote transmitter. Note
11-45.
2-
Advertisement
Chapters
Table of Contents
