Zte MF93D User Manual page 2

2. Right-click Wireless Network Connection, and then select Prop-
erties.
4. Connect to the WLAN device.
There are two methods for your reference.
Select the listed SSID, and then click Connect.
u
Click Add, input the WLAN device information in the Add Wi-Fi
u
Hotspot area, and then click Apply.
3. Select Internet Protocol(TCP/IP), and then click Properties.
5. After your device connected to the WLAN device successfully, you
can access the Internet.
Configuring Your PC
Follow the following steps and figures
for Windows XP to configure the Internet
Protocol for your Wi-Fi connection.
1. Right-click My Network Places, and
then select Properties.
10 11
4. Select Obtain an IP address automatically and Obtain DNS on. Turn your device off if necessary. Consult a physician or the
server address automatically, and then click OK to finish the con- manufacturer of the medical device before using your device.
figuration. • The device complies with RF specifications when the device is used
at 1cm from your body.
• Be aware of the usage limitation when using your device at places
such as oil warehouses or chemical factories, where there are ex-
plosive gases or explosive products being processed. Turn off your
device if required.
• The use of electronic transmitting devices is forbidden in aircrafts,
at petrol stations and in hospitals. Please observe and obey all
warning signs and switch off your device in these conditions.
• Do not touch the inner antenna area if not necessary. Otherwise it
will affect your device's performance.
• Store your device out of the reach of little children. Your device may
cause injury if used as a toy.
• Do not touch the metallic parts of your device so as to avoid a burn,
Warning and Notice when your device is working.
Using Your Device
To the Owner
• The device is for indoor use only. Do not use the device outside.
• Some electronic devices are susceptible to electromagnetic inter-
The device does not support DFS.
ference sent by your device if inadequately shielded, such as the
• Please use original accessories or accessories that are authorized.
electronic system of vehicles. Please consult the manufacturer of
Using any unauthorized accessories may affect your device's per-
your device before using if necessary.
formance, and violate related national regulations about telecom
• Operating your device may interfere with medical devices like hear-
terminals.
ing aids and pacemakers. Please always keep them more than 20
centimeters away from such medical devices when they are turned
12 13
• Avoid using your device near or inside metallic structures or estab- • Do not disassemble or modify the battery.
lishments that can emit electromagnetic waves. Otherwise it may • Never use any charger or battery damaged or worn out.
influence signal reception. • Return the wear-out battery to the provider or put it in the appointed
• Your device is not waterproof. Please keep it dry and store in a recycle place. Do not put it in familial rubbish.
shady and cool place. WARNING:
• Do not use your device immediately after a sudden temperature Do not change the built-in rechargeable battery in your device by your-
change. In such case, it will produce dew inside and outside your self. The battery can only be changed by ZTE or ZTE authorized ser-
device, so don't use it until it becomes dry. vice provider.
• Handle your device carefully. Do not drop, bend or strike it. Other-
Limited Warranty
wise your device will be damaged.
• This warranty does not apply to defects or errors in the Product
• No dismantling by non-professionals and only qualified technicians
caused by:
can undertake repair work.
i. Reasonable abrasion.
• Operating temperature range of 0°C ~ +35°C and humidity range of
ii. End User's failure to follow ZTE's installation, operation or main-
5% ~ 95% are recommended.
tenance instructions or procedures.
About your Adapter
iii. End User's mishandling, misuse, negligence, or improper installa-
• Adapter shall be installed near the equipment and shall be easily tion, disassembly, storage, servicing or operation of the Product.
accessible. iv. Modifications or repairs not made by ZTE or a ZTE-certified in-
• Model: ZTE MF93D dividual.
• Manufacturer: ZTE Corporation v. Power failures, surges, fire, flood, accidents, actions of third
• The plug considered as disconnect device of adapter. parties or other events outside ZTE's reasonable control.
vi. Usage of third-party products, or usage in conjunction with third-
Using Battery
party products provided that such defects are due to the com-
• Do not short-circuit the battery, as this can cause excessive heat
bined usage.
and fire.
vii. Any other cause beyond the range of normal usage intended for
• Do not store the device in hot areas or dispose of it in a fire to avoid
the Product.
explosion.
14 15
End User shall have no right to reject or return the Product, or receive a
Problem Suggested Solution
refund for the Product from ZTE under the above-mentioned situations.
• Make sure the Wi-Fi function is active. Press
• This warranty is End User's sole remedy and ZTE's sole liability
the WPS button to enable or disable
for defective or nonconforming items, and is in lieu of all other war-
Wi-Fi function.
ranties, expressed, implied or statutory, including but not limited to
Can not establish
• Refresh network list and select the correct SSID.
the implied warranties of merchantability and fitness for a particular the Wi-Fi connection
• Check the IP address to make sure your cli-
purpose, unless otherwise required under the mandatory provisions between your device
ent can obtain an IP address automatically in
of the law. and client
the Internet protocol (TCP/IP) properties.
Limitation of Liability
• Type the correct network key (Wi-Fi pass-
ZTE shall not be liable for any loss of profits or indirect, special, inci-
word) when you connect to the device.
dental or consequential damages resulting from or arising out of or in
• Make sure your (U)SIM card is available.
connection with using of this product, whether or not ZTE had been ad-
• Change the location to find a place with good
vised, knew or should have known of the possibility of such damages, The client connected
signal.
including, but not limited to lost profits, interruption of business, cost of to the device can not
• Check WAN Connection mode setting.
access the Internet
capital, cost of substitute facilities or product, or any downtime cost.
• Contact with your service provider and con-
Troubleshooting
firm your APN settings.
Problem Suggested Solution When I use Internet • Make sure the other WLAN device has al-
Wi-Fi mode, the ready connected to the Internet.
• You need to install the software. Run the in-
client cannot access • Make sure that the subnet of your device and
Can not establish stallation program in path of My Computer >
the Internet. the other WLAN device is different
the USB connection ZTEMODEM.
• Enter the correct address. The default ad-
between your device • If the driver of your device is abnormal, Can not visit the
dress is http://192.168.0.1 or http://m.home.
and PC please reinstall the software. You need unin-
webGUI configura-
• Only use one network adapter in your PC.
stall the software first.
tion page
• Do not use any proxy server.
16 17
Problem Suggested Solution
• Press the WPS button twice, and then the
SSID and Wi-Fi connection password appear
on the screen.
• The default password of the webGUI configu-
About the password
ration page is admin.
• If you changed the password and forgot the
new password, you need to restore the de-
vice to the factory default settings.
• Press the reset button, the device will reset
to the default settings.
About the device • If there is any exception while using the de-
vice, please press and hold the Power But-
ton for about 10 s, and the device will restart.
For more assistance, please:
• Send E-mail to mobile@zte.com.cn
• Visit http://www.zte.com.cn
• Call Service Hotline: +86–755–26779999
18