Pre-Installation - GBC Falcon 60+ (-1) Operation & Maintenance Manual

Operations Manual
© 2003 General Binding Corporation
Fig 2
Pre- Installation
Before a Falcon 60+ (-1) Laminator can be installed,
ensure the following requirements are met;
1. Are door ways and hallways wide enough for the
laminator to be moved to the installation site?
2. Is there ample room for the laminator?
– A work area must be established that allows for
operation in both the front and rear of the laminator
and provides space for efficient material flow.
(Figure 2)
3. Is the environment appropriate for the laminator?
– The laminator requires a clean, dust and vapor
free environment to operate properly.
– Avoid locating the laminator near sources of heat
or cold. Avoid locating the laminator in the direct
path of forced, heated or cooled air.
CAUTION: Air flow can cause uneven
heating/ cooling of the rollers and result in
poor output quality
4.Have you contacted a certified electrician to wire
the receptacle and ensure that adequate power is
being supplied, having the appropriate capacity,
over current protection and safety lockouts
available?
– 220V at 60hz with 25 amp service. Use the
receptacle supplied with your machine (Nema 6-
30R).
Falcon 60+ (-1) Falcon 60+ (-1)
Page 7