Fujitsu Siemens Computers LIFEBOOK E Series User Manual page 60

Hide thumbs Also See for LIFEBOOK E Series:

Table of Contents

Security functions

To set the passwords, proceed in the following order:

Assigning the supervisor password

The setup programme can be found under Start - AddOn.

Double-click on the symbol to start the setup programme for FJSECS.EXE.

The programme starts.

Enter the programme name FJSECS.EXE under Start - Run.

Click on OK.

The programme starts.

The program instructions will help you configure the password.

With a combination you must press the security keys with these numbers simultaneously

later when entering the password.

You see a field with five lines and 4 keys each

with the numbers 1 to 4 for selecting your

password. You can select one number or a

combination of several numbers in each line.

Click one to four keys in the first line.

You can also click a key or key combination

in additional lines if desired.

Here it is important that you do not skip a line. In

the end your password consists of one to five

numbers or one to five number combinations.

An example:

Here the combination 2, 3 was selected in the

first line, the number 4 in the second line, the

combination 1, 3 and 4 in the third line, the

number 2 in the fourth line and finally the

combination 1, 2, 3 and 4 in the fifth line.

In this case the supervisor password is then:

2/3 4 1/3/4 2 1/2/3/4

A26391-K121-Z120-2-7619

Table of Contents

Troubleshooting