Advertisement
Installation & Mounting:
Permanent Mounting:
Select the mounting location for the lightbar on a flat, smooth surface. If the lightbar is to be mounted on a curved surface,
such as on the roof of the vehicle, choose a placement with the least amount of curvature. The mounting location for the
lightbar should be chosen such that there is maximum visibility to the oncoming traffic.
CAUTION!
When drilling into any vehicle surface, make sure that the area is free from any electrical wires, fuel
lines, vehicle upholstery, etc. that could be damaged.
Use the following instructions for mounting (refer to Figures 1 & 2).
1.
Drill four (4) mounting holes and one (1) wire access hole as shown in the pattern in Figure 1 below. The lightbar is
designed with slots on the bottom for mounting. This allows for variable mounting centers along the length of the
lightbar, adding versatility.
2.
Wire the lightbar (see the section on wiring).
3.
Insert the head of one of the bolts into the opening at the end of one of the slots on the base, and slide into position.
Repeat for the other three bolts, and place the rubber spacers onto the bolts. These spacers mount between the
bottom of the lightbar and the mounting surface.
4.
Mount the lightbar with the bolts through the holes drilled in Step 2 above, and secure with the flat washer, lock
washer and nut as shown in Figure 2.
920-0003-00 Rev. B
3.94"
P (0.3230")
TO
Q (0.3320")
4 PL.
17.38" (Max.)
12.00" (Min.)
PLACE HOLE NEAR CENTER FOR WIRE
ACCESS. THE USE OF A GROMMET
(USER-SUPPLIED) IS RECOMMENDED
TO PROTECT THE WIRES PASSING
THROUGH ROOF. HOLE DIAMETER IS
DEPENDENT ON GROMMET.
Figure 1
Figure 2
Page 2 of 5
Advertisement
