Rorke Data Galaxy Aurora LS Series Configuration And Setup page 87

G A L A X Y ® A U R O U R A L S C O N F I G U R A T I O N A N D S Y S T E M I N T E G R A T I O N G U I D E
The main IPMI window should appear as follows:
You can get into the IPMI card at any time.
If you left-click on Power Down, as in the image above, and the array is powered on, you won't
be able to stop it – it will be off as if the power switch itself was pressed. Also, if you left-click
on the Reset button, the array will reboot as if you actually hit the reset button on the front.
You can turn on the array via the power on button. Once the array is on and starting to boot,
you can click on the small window in the middle and bring up the console as if you were
actually looking at it on the monitor. This is the primary area where you may have to
troubleshoot the array. You can even view or control the BIOS from here. On the left, each of
these items is a menu which expands downward if you click on them. If you are
troubleshooting power problems, the main item that you want is System Health. Once you've
left-clicked on this, you can click on "Monitor Sensors."
86 Section 4 Troubleshooting Guide