Run A Cli Command From Webmin; Change The Network Host Name; See And Control Smart For The Boot Device - Rorke Data Galaxy Aurora LS Series Configuration And Setup

G A L A X Y ® A U R O U R A
Left-click on the option within this group, called Change Passwords.
Left-click on the user name whos password you would like to change.
Type the new password (twice).
Make sure the Force user to change password at next login? option is NOT checked, and
make sure the Change password in other modules? option IS checked, then left-click on the
Change button.
To return to the NumaRAID GUI, expand the Hardware category on the left, if it is not already,
and left-click on NumaRAID GUI.

Run a CLI command from Webmin

It is possible to run CLI commands from Webmin. To do so, do the following:
Expand the "Others" group on the left if it is not already.
Left-click on Command Shell below the Others group.
Type the command you would like, and press [enter].
To return to the NumaRAID GUI, expand the Hardware category on the left, if it is not already,
and left-click on NumaRAID GUI.

Change the Network Host Name

To change the network host name, do the following:
Expand the Networking group on the left if it is not already.
Left-click on Network Configuration.
The screen on the right will change, left-click on Hostname and DNS Client.
At the top, change the hostname.
At the bottom, left-click on the Save button.
To return to the NumaRAID GUI, expand the Hardware category on the left, if it is not already,
and left-click on NumaRAID GUI.

See and Control SMART for the Boot Device

You can see the status of SMART for the boot device, as well as run SMART diagnostic tests
on it, by doing the following:
Expand the Hardware group on the left if it is not already.
Left-click on SMART Drive Status.
At the top of the screen, make sure the boot drive is selected.
Left-click on the Show button.
102
L S C O N F I G U R A T I O N A N D S Y S T E M I N T E G R A T I O N
Section 5 Application / Technical Notes
G U I D E