Default To Numaraid Gui After Login; Make The Numaraid Gui A Little Faster - Rorke Data Galaxy Aurora LS Series Configuration And Setup

G A L A X Y ® A U R O U R A

Default to NumaRAID GUI after Login

You can set Webmin, so that the NumaRAID GUI is always the first thing which appears after
login by doing the following:
Expand the Webmin Group if it is not already, so that you can see the items under it.
Left-click on the Webmin Configuration item below the Webmin Group.
On the right, left-click the icon which reads "Index Page Options."
Near the bottom of the table is a line which reads "After login, always go to module" – next to
this is a drop-down. Left-click on the drop-down, and select NumaRAID GUI.
Left-click on the Save button at the bottom of the screen.
To return to the NumaRAID GUI, expand the Hardware category on the left, if it is not already,
and left-click on NumaRAID GUI.

Make the NumaRAID GUI a Little Faster

You can make the NumaRAID GUI a little bit faster by forcing Webmin to cache it's libraries.
To do this, do the following:
Expand the Webmin Group if it is not already, so that you can see the items under it.
Left-click on the Webmin Configuration item below the Webmin Group.
On the right, left-click the icon which reads "Advanced Options."
The fourth item down reads "Pre-load Webmin functions library." Select the bubble next to
Yes.
Left-click on the Save button at the bottom of the screen.
To return to the NumaRAID GUI, expand the Hardware category on the left, if it is not already,
and left-click on NumaRAID GUI.
100
L S C O N F I G U R A T I O N A N D S Y S T E M I N T E G R A T I O N
Section 5 Application / Technical Notes
G U I D E