[Bst940] Easy Setting; Number Buttons - Panasonic DMR-BCT940 Operating Instructions Manual

[BST940] Easy Setting

1
Turn on the TV, then select the appropriate
AV input to suit the connections to this unit.
2
Press [Í] on the remote control or [Í/I] on
this unit.
• The Easy Setting will start at the initial
power on.
3
Select language, then press [OK].
4
Select country, then press [OK].
5
Select the search mode, then press [OK].
6
Select "Single Cable System", "DiSEqC
(Dual Tuner)" or "DiSEqC (Single Tuner)"
then press [OK].
When selecting "Single Cable System"
1 Make the settings of user band.
User Band Settings
Start Auto Setup
Please confirm user band settings before starting Auto Setup.
Tuner 1
User Band
User Band Frequency
User Band PIN
Tuner 2
User Band
User Band Frequency
User Band PIN
Tuner 3
User Band
User Band Frequency
User Band PIN
Select
OK
RETURN
• User Band
You can set C1 to C8. Set to a User Band
not used by any other device.
• When only one User Band of the
Router is assigned, set "Tuner 2" and
"Tuner 3" to "OFF".
Note that you will not be able to record
two programmes simultaneously.
When two User Bands of the Router
are assigned, set "Tuner 3" to "OFF".
Note that you will not be able to record
three programmes simultaneously.
• User Band Frequency
Set the User Band Frequency with

number buttons.

• User Band PIN
If the single cable router requires a PIN
to access an user band, enter the PIN.
C1
1284 MHz (preset: 1284 MHz)
Off
C2
1400 MHz (preset: 1400 MHz)
Off
C3
1516 MHz (preset: 1516 MHz)
Off
• For details, read the manual of the single
cable router, etc.
2 Select "Start Auto Setup", then press
[OK].
Auto Setup starts.
These operations (Searching Satellite and
Searching Channels) may take some time.
• When selecting "DiSEqC (Dual Tuner)" or
"DiSEqC (Single Tuner)"
Auto Setup
Satellite Checking LNB1
Progress 0%
This will take up to 40 minutes.
LNB in 1 Checking...
Satellite
Press RETURN to skip Satellite installation
Searching Satellite
RETURN
• When selecting "Single Cable System"
Auto Setup
Satellite Checking LNB1
Progress 0%
This will take up to 40 minutes.
Checking...
Tuner 1
Tuner 3 Checking...
Satellite
Press RETURN to skip Satellite installation
Searching Satellite
RETURN
After tuning has been completed, clock will
be set automatically.
If the clock setting screen appears, set the
time manually (
7
Set Quick Start to "On", "Off" or "Timer
Setting for Quick Start", then press [OK].
• On
It is possible to start quickly from standby
mode.
• Off
Power consumption in standby mode is
minimized. ( 118)
However, startup time from standby mode
will be longer.
• Timer Setting for Quick Start
"Quick Start" is activated when the set time
comes.
Getting started
100%
LNB in 2 Checking...
100%
Checking...
Tuner 2
102, Clock).
SQT0292
25