Table of Contents
Advertisement
Quick Links
120V AC Wire-In Smoke Alarm
Slide Load Front Battery Door
Model i4618
– Ionization Sensing Technology
– Battery Backup (batteries included)
– Hush
®
Button
– Alarm Memory Indicator
– New 360˚ Mounting Plate
with Tamper Resistance
– Front Load Battery Door
Description
The Kidde i4618 is an AC/DC powered, ionization smoke
alarm that operates on a 120V power source with 9V
battery backup.
This alarm uses ionization sensing technology. Ionization
sensing alarms may detect invisible fire particles
(associated with flaming fires) sooner than photoelectric
alarms. Photoelectric sensing alarms may detect visible
particles (associated with smoldering fires) sooner than
ionization alarms.
Kidde strongly recommends that both ionization
and photoelectric smoke alarms be installed to help
insure maximum detection of the various types of
fire that can occur within the home.
The front-loading battery door allows user to change the
battery without removing the alarm from the mounting
bracket making battery replacement easy and convenient.
This smoke alarm is available in a 6-piece cut case with
tray for easy display as well as a 6-piece bulk pack for
contractors and property owners. This unit is a UL Listed
product with a 5-year limited warranty.
Install Confidence:
Easy Installation
• Front battery pull tab allows battery activation
without removing alarm from mounting bracket.
• Large mounting base makes mounting easier, protects
surface paint from dirt and covers imperfections.
• Pre-stripped wiring harness with easy off cap does
not require stripper tool. Tinned strands increase
conductivity and wire nut grip.
Fewer Callbacks
• Large centrally located Test/Hush
• Dust cover protects sensor from contaminates during
construction reducing nuisance alarms.
User-Friendly Features
• Easy access front loading battery door.
• Battery backup provides protection in case of
power failure.
• Interconnectable with up to 24 devices (of which 18
can be initiating) including smoke, CO and heat
alarms. See user's guide for complete instructions.
alarm control button.
®
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Kidde I4618
Summary of Contents for Kidde I4618
- Page 1 – New 360˚ Mounting Plate with Tamper Resistance – Front Load Battery Door Description The Kidde i4618 is an AC/DC powered, ionization smoke alarm that operates on a 120V power source with 9V battery backup. This alarm uses ionization sensing technology. Ionization...
-
Page 2: Specifications
Architectural and Engineering Specifications The smoke alarm shall be Kidde Model i4618 or approved equal. It shall be powered by a 120VAC, 60Hz source along with a 9V battery back- up. The unit shall incorporate an ionization sensor with nominal sensitivity of 0.50 to .92%/ft.
Need help?
Do you have a question about the I4618 and is the answer not in the manual?
Questions and answers
How do I reset my Kidde Smoke Alarm Model |4618 AC
To reset the Kidde Smoke Alarm Model i4618:
1. Turn off the power to the smoke alarm at the circuit breaker.
2. Remove the smoke alarm from the mounting bracket.
3. Disconnect the power connector.
4. Remove the battery.
5. Press and hold the test button for 15-20 seconds to discharge any remaining power.
6. Reconnect the power connector.
7. Insert a fresh 9V battery.
8. Reattach the alarm to the mounting bracket.
9. Restore power at the circuit breaker.
This resets the alarm and should stop any false chirping if the issue was power or battery related.
This answer is automatically generated