Sony HVR-M15J Service Manual page 113

3-18. MAIN SLIDER, MAIN SLIDER ARM AND PENDULUM STOPPER ASSEMBLY
Disassembly: Remove them in order of 1,2,3
Main slider
1
Pendulum
stopper assembly
Bent portions
Assembly: Attach them while referring to the figure
Assembly of each part
Attach each part while referring to the figure above or below. When
attaching the parts, adjust the positions carefully while referring
to the instructions in the figure below. Because these positioning
will be used as a reference when assembling in future, make sure
to adjust the positions and phases correctly.
Pendulum stopper assembly
The shaft of the ratchet brake T
should be at the position where
it can be viewed fromthe outside
as shown in the figure.
HVR-M15J/M15U/M15N/M15E/M15P/M15C
2
above or below and the descriptions.
[Rear side of chassis]
1
3 4
2
Move the main slider so that
the positioning holes are
superimposed.
Disassembly of each part
The main slider controls several parts. Before removing the main
slider, remove "Brake arm S" at the front of the chassis while re-
ferring to "Information" on page 6-5. Otherwise, the main slider
cannot be removed.
3
Main slider arm
Fixing shaft of
main slider arm
Fixing hole of
main slider arm
1 Insert the main slider arm into the fixing hole and attach
2 Perform assembly so that the main slider can pass under
3 Carefully attach the pendulum stopper assembly so that
Main slider arm
5
4 Attach the shaft of the main slider arm to the long hole
Main slider
5 Move the main slider to the leftmost end so that the
6-19
Brake arm S
Main slider
The main slider is fixed by the two shafts and the two
bent portions at the rear of the chassis. The main slider
can be removed when it is moved to the rightmost end
( positions).
Shafts
Bent portions
it to the fixing shaft at the front of the chassis while
referring to the figure above. (To facilitate assembly,
stick adhesive tape so that the main slider arm does not
drop.)
the bent portion of the chassis. If "Ratchet brake T"
remains, move down the "Ratchet brake T" as shown in
the left figure and attach the main slider.
the two shafts fit in the two long holes of the main slider.
Main slider
Pendulum stopper assembly
of the main slider.
small positioning hole of the main slider is superimposed
on the small positioning hole of the chassis, and fix the
main slider. The position where the main slider is fixed
will be used as a reference during assembling and phase
adjustment in future.
(To avoid affecting the main unit, fix the reel motor and
main slider with adhesive tape, etc.)
shafts