Sony HVR-M15J Service Manual page 107

3-9. PINCH ARM ASSEMBLY
Disassembly/Assembly
For the disassembling and assembling procedures of the tape re-
tainer and compression coil spring (tape retainer), refer to page 6-
22.
Roller
Claw
Push roller A into the
groove as shown in the
figure. Insert roller B into
the claw. To remove the
pinch arm assembly, pull
out the pinch arm upward
while pushing the claw.
3-11. PENDULUM RETAINER AND PENDULUM ARM ASSEMBLY
Disassembly: Remove them in order of 1,2,3
(To attach them, perform the disassembly steps in reverse order.)
1
Screw
3
Pendulum arm
assembly
Shaft
Shaft
Positioning boss
HVR-M15J/M15U/M15N/M15E/M15P/M15C
Roller
A
B
Pinch arm assembly
Roller
Claw
Roller
B
Tightening torque of pendulum retainer
0.3432 ± 0.0196 N • m (3.5 ± 0.2 kg • cm)
2
Pendulum retainer
(Remove in the direction
of the arrow.)
Shaft
A
B
Shaft
B
3-10.
Disassembly/Assembly
(After assembling, adjust the tape path from page 6-23.)
Capstan motor
A
Notes during assembly
When assembling or disassembling the pendulum arm assembly,
be careful of the following.
Insert tip
arm into hole
retainer and insert the pendulum
into shaft
Attach the pendulum retainer to shaft B. Be careful of the positions
of the pendulum stopper at the rear of the chassis and shaft A of
the pendulum arm.
Cannot be removed.
6-13
CAPSTAN MOTOR
Be careful not to touch the
motor shaft (
Screw
Tightening torque of capstan motor
0.1961 ± 0.0196 N • m (2.0 ± 0.2 kg • cm)
[Rear side of pendulum retainer]
Hole
E
D
Shaft
C
of the pendulum
D
of the pendulum
E
.
C
Shafts
B
Can be removed.
Shafts
B
part).
F
Shaft
C
Slide the pendulum arm in
the direction of arrow and
F
attach it to the chassis.
Pendulum stopper
Shaft of the pendulum
A
must be in this position.