Sony HVR-M15J Service Manual page 112

L
Shaft J
Groove K
Main cam gear
Encoder gear
Fig. 8
Sub-cam gear
Not
good
Main cam gear
Fig. 11
Phase pin F should be fitted in
the long hole of the sub-slider arm.
Fig. 13
HVR-M15J/M15U/M15N/M15E/M15P/M15C
[Front side of chassis]
Sub-cam gear
▲ marks should face
each other.
a marks should face
each other.
Not
good
[Front side of chassis]
Phase pin C should be fitted in
the groove of the main cam gear
(front side).
Sub-slider arm
Sub-slider
Reel base S
Reel base T
4 Apply grease to the fixing block (shaft J and U-shaped groove
K) of the coupling gear and portion L of the sub-cam gear
(half size of one grain of rice for each part). (Fig. 8)
5 Attach the coupling gear. After attaching, apply grease while
rotating the coupling gear by 120˚ each time. (Fig. 9, 10)
U-shaped groove K
Fig. 9
Apply grease to the three
(half size of one grain of rice for each part).
120 °
120 °
6 Attach the main cam gear while being careful of the directions
of the front and rear sides. Also, take care of the phase
adjustment to the sub-cam gear. (Fig. 8, 11, 12)
Phase pin M of the main slider arm should be fitted in the
groove of the main cam gear (rear side). (Fig. 5)
Main cam gear (rear side)
( a does not exist.)
7 Attach the encoder gear. (Fig. 3)
Adjust the phases (marked) to those of the main cam gear. (Fig.
4/Fig. 8)
8 After moving the reel selector slider in the direction of arrow
N to set the position of the reel base to "L cassette", attach the
sub-slider in reverse order while referring to Fig. 3. (Fig. 13)
9 Attach the sub-slider arm. (Fig. 1/Fig. 13)
N
(Position when L cassette is set)
6-18
Shaft J
Attach the coupling gear to shaft J
and U-shaped groove K in order.
parts
120 °
Fig. 10
Main cam gear (front side)
( a exists.)
Fig. 12
Do not hold the shaft
when selecting the reels.
Reel selector slider
(After attaching the sub-slider arm,
return the reel base to the original
position (L cassette).)