Table of Contents
Advertisement
Important Safety Information
lation
Notes
Introduction
Intro
Operation
WARNING Power inverters contain components
that can produce arcs or sparks. To prevent fire
or explosion, do not install the inverter in areas or
otice
Caution
Warning
compartments containing batteries or flammable
materials or in locations that require ignition-
Installation
protected equipment.
Secondary Icons
WARNING To reduce the risk of fire, do not cover
or obstruct the ventilation openings. Do not install
inverter in zero-clearance compartment.
Proposition 65: Warning: Wash Hands After
Handling Power Cord
The power cord on this product contains lead, a chemical
known in the state of California to cause birth defects or
other reproductive harm.
Caution: Rechargeable Appliances
Certain chargers for small nickel cadmium batteries can be
damaged if connected to the Cobra 400 watt inverter. Two
particular types of equipment are prone to this problem:
Plug In Directly
Dangerous
Voltages
This problem does not occur with the vast majority of
battery operated equipment. Most use a separate charger
or transformer that is plugged into the AC receptacle
and produces a low voltage output. If the label on the AC
adapter or charger states that it produces a low voltage
AC or DC output (less than 30 volts), the inverter will
have no problem powering the adapter safely.
2
Customer
Warranty
Assistance
Notes
Notice
Caution
Warning
1. Small battery-operated appliances
such as flashlights, razors, and
night lights that can be plugged
Main Icons
directly into an AC receptacle to
recharge.
2. Certain battery chargers for
battery packs used in hand power
tools. These chargers have a
Intro
WARNING label stating that
dangerous voltages are present
at the battery terminals.
Secondary Icons
Introduction
Output Waveform
Some very sensitive electronic equipment may not operate
satisfactory on "square wave" or "modified sine wave."
The output waveform is referred to as "square wave" or
"modified sine wave." It is a stepped waveform designed to
have characteristics similar to the sine wave shape of utility
power. A waveform of this nature is suitable for most AC
Secondary Icons
loads (including linear and switching power suppliers used
in electronic equipment, transformers and motors).
Quick Evaluation Before Installation
This section provides you with basic information about the
inverter and how to check its performance before installation.
Be sure to have on hand:
£ A 12 volt DC power source (such as a vehicle battery).
Power Supply
£ The provided two foot cigarette lighter cable and
two foot direct-to-battery 12 gauge cable.
Only use the cables provided with your inverter.
The cigarette lighter cable is suitable for operating the
inverter at loads up to 150 watts. Connect by securely
inserting the plug into the cigarette lighter socket.
Operation
Customer
Warranty
Assistance
Cig. Lighter Cable
Installation
Notes
CAUTION Do not use the cigarette lighter cable
for loads higher than 150 watts. When connecting
loads larger than 150 watts, please connect the
Notice
Caution
Warning
inverter directly to the battery.
Quick Evaluation
Before Installation
Intro
Operation
Customer
Assistance
Installation
Notice
Caution
The power source must provide
between 11 and 15 volts DC and
be able to supply enough current to
run the test load. As a rough guide,
divide the wattage of the test load by
10 to get the current (in amperes)
the power source must deliver.
12 Gauge Cable
Nothing Comes Close to a Cobra
Warranty
Notes
•
Warning
3
®
Advertisement
Table of Contents
