Page 1
ARC417 Series Si10-416A ARC417A14, A15 Open cover. ON/OFF TEMP TIME DOWN OFF TIMER CANCEL ON TIMER MODE SWING SILENT POWERFUL HOME LEAVE Remote Controllers...
Page 2
Si10-416A ARC417 Series 1. Transmitter It sends signals to the indoor unit. 2. ON/OFF button Press it once to start operation. To stop it, press it once again. 3. Display It displays the current settings.(In this illustration, each ...
ARC417 Series Si10-416A 3. ARC417 Series 3.1 Preparation Before Operation Remote controller Setting the batteries Position + and – correctly! Address switch Press with a finger and slide the back cover to take it off. Set two alkaline dry batteries (LR03). Set the back cover as before.
Page 4
Si10-416A ARC417 Series Operating the remote controller O To use the remote controller, aim the transmitter at the indoor unit. If there is anything to block signals between the unit and the remote controller, such as a curtain, the unit will not operate. O Do not drop the remote controller.
ARC417 Series Si10-416A Indoor unit Setting the air purifying filters Open the front grille. OHold the grille by the tabs on the two sides and lift it until it stops with a click. (about 60˚) Pull out the air filters. OPush upwards the tab at the center of each air filter, then...
Si10-416A ARC417 Series Setting the clock Press is displayed. blinks. Press to set the clock to the present time. OHolding down ( ) or ( ) button rapidly increases or decreases the time display. Press blinks. Turn the breaker ON ...
ARC417 Series Si10-416A NOTE Tips for saving energy OBe careful not to cool (heat) the room too much. Keeping the temperature setting at a moderate level helps save energy. Recommended temperature setting For cooling: 26˚C – 28˚C For heating:20˚C – 24˚C OCover windows with a blind or a curtain.
Page 22
Si10-416A ARC417 Series NOTE <Note on HOME LEAVE Operation> O HOME LEAVE Operation is only available in COOL and HEAT modes. (Cannot be used in AUTO, DRY, and FAN modes.) O HOME LEA VE Operation runs in accordance with the operation mode the unit was in before using HOME LEAVE Operation.