Sanding Tips; Sanding Operations - Bosch 1810PS Operating/Safety Instructions Manual

BM 1609929J65 01-11:BM 1609929J65 01-11 1/20/11 10:41 AM Page 15
the material being cut. Do not exert side
pressure onto the cutting disc, tilt or oscillate
the tool. When cutting profiles and square
bar, it is best to start at the smallest cross
section.
Always follow precautions for kickback.
Do not apply side pressure to cutting wheel
to reduce wheel speed.
The tool should always be used so that
sparks are directed away from user.
CUTTING MASONRy
Operate the tool only with dust extraction and
additionally wear a dust protection mask. The
vacuum used for this application must be
approved for the extraction of masonry dust.
Bosch sells suitable vacuum cleaners.
When cutting masonry always
WARNING
use dust extraction with foot
plate. The tool may be used only for dry
cutting. When cutting masonry use a dry
diamond wheel.
Always cut towards the dust extraction port
(Fig. 10).
Turn the tool on and place the front part of the
cutting guide on the workpiece. Slide the tool
with moderate rate of feed, adapted to the
material to be cut.
SELECTING SANDING DISC
Sanding discs are made of extremely hard
and sharp aluminum oxide grits, phenol-resin
bonded to a sturdy fiber backing for fast
heavy-duty service and long life. The discs
vary as to size and spacing of the abrasive
grits. OPEN COAT (type H) — used for soft
materials and on paint or varnish. CLOSED
COAT (type K) —used for metal, hardwood,
stone, marble and other materials.
Sanding discs range in grit from 16 (very
coarse) to 180 (very fine). To obtain best
results, select sanding discs carefully. Many
jobs require the use of several grit sizes and

SANDING TIPS

For best results, tilt the Disc Sander at a 10°
to 15° angle while sanding so that only about
1" of the surface around the edge of the disc
contacts the work.
FIG. 10
When doing deep cuts, it is best to cut in
several shallow passes.
When cutting especially hard material, e. g.,
concrete with high pebble content, the dry
diamond wheel can overheat and become
damaged. This is clearly indicated by circular
sparking of the rotating dry diamond wheel.
In this case, interrupt the cutting process and
allow the dry diamond wheel to cool by running
the tool for a short time at maximum speed
with no load.
Noticeable decreasing work progress and
circular sparking are indications of a dry
diamond wheel that has become dull. Briefly
cutting into abrasive materials (e. g. brick) can
resharpen the wheel again.

Sanding Operations

at times both "open coat and closed coat"
discs are required to get the job done faster.
See chart for application examples.
Operation: Refinishing painted wood or metal surfaces.
REMARKS
To remove paint and to smooth
surface irregularities.
To smooth
the rough sanding.
To remove scratches left by
previous discs.
To smooth surfaces for painting,
polishing or waxing.
-15-
GRIT
Coarse
16-24-30
Medium
36-50-80
Fine
100-120
Very Fine
150-180