Advertisement
IMPORTANT: Read the following safety and operation instructions to avoid injury and to avoid
damage to equipment or property.
Plug unit into a properly grounded electrical outlet of the correct voltage, size and plug configuration for this unit. We recommend usage
!
on an individual branch circuit of at least 15 amps for best results. Failure to do so may result in decreased performance of the warmer.
The oven should never be operated on or near combustible materials. Caution should be taken because of the hot surfaces attained
!
during use. We recommend a 6" spacing from walls.
!
Exterior surfaces on unit may get hot. Use caution when touching these areas to avoid injury.
Improper assembly of the "flip up" handle to the grill could cause the grill to rotate the pizza when the pizza is removed from the oven
!
resulting in hot food falling off the grill. See proper handle assembly instructions included in this instruction manual.
!
When removing grill from oven, use caution to avoid hot food falling into the oven, on the operator, etc.
!
Unplug oven when not in use
!
Unit is not waterproof. Do Not submerge in water. Do not operate if unit has been submerged in water.
Unplug unit from power source and allow to cool completely before performing any maintenance or cleaning.
ASSEMBLING COMPONENT PARTS
Included with your oven is a plastic bag containing the grill handle, clean-out tray knob and
appropriate screws and nuts. See the instruction sheet for assembling the flip up handle and
clean-out tray.
CLEANING INSTRUCTIONS
Unplug oven and allow to cool before cleaning. This oven is designed with a clean-out tray which
should be pulled out and cleaned often with warm soapy water and then dried thoroughly. Most of
the spillage will fall directly on this tray. If spillage is cleaned off and not allowed to accumulate, the
internal parts of the oven will stay relatively clean. Additionally, proper cleaning prevents emergence
of smoke caused by a build up of carbon. The outside of the oven may be cleaned with a soft rag
and stainless steel cleaner. As with all metals, there could be some sharp edges and caution should
be used when cleaning.
- DO NOT USE ACIDS OR CAUSTIC PRODUCTS SUCH AS FOAMING OVEN CLEANERS.
- AVOID USING ABRASIVE/SCOURING PADS AS SOME MAY CAUSE SCRATCH MARKS ON UNIT.
HOW TO CONTACT US:
If you have further questions in regards to this piece of equipment - please contact Wisco Industries, Inc.
directly at: (608)835-3106 or (800)999-4726; fax (608)835-8273 for further information.
*Please be sure to have the complete model # and serial # available.
Advertisement
