Front Drop-Down Solar/Night Shade (12-Volt); Brake-Shift Interlock - Winnebago SunCruiser User Manual

SECTION 3 –
DRIVING YOUR MOTOR HOME
Mirror Head Pivot Lock
• Loosen Allen head set
screw to pivot mirror head
(Torque 75-100 in/lbs)
NOTE: Set screws may be located on the
opposite side of the mirror arm.
Passenger side mirror is similar.
FRONT DROP-DOWN SOLAR/
NIGHT SHADE (12-VOLT)
Your coach is equipped with a 12V Front
Drop-Down Solar/Night Shade that provides
privacy and solar heat protection as well as a
sunvisor feature.
The power switches for the 12V Front Drop-
Down Solar/Night Shade are located on the dash
or driver side trim panel, depending on model.
12-Volt Front Drop-Down Solar/
Night Shade Switches
-Typical View
Press the Solar Shade (black) or the Night
Shade (white) switch up or down to adjust the
shade to the setting that best suits your needs.
3-6
Dual range motors provide lowering of either
two shades to visor height restriction when the
ignition is ON and lowers completely to cover the
entire windshield when the ignition is OFF.
The Chassis Battery Disconnect switch must
be ON to supply power to the solar/night shade.
NOTE: If power is gradually drained and falls
below the lower limit of 11-volts, the
motors may lose their electronic set
limits and will require reprogramming
once normal power has been restored.
Refer to the Solar/Night Shade
manufacturer's information provided in
your InfoCase.
Automatic Safety Retraction
-If Equipped
The Solar/Night Shade in your vehicle may be
equipped with an Automatic Safety Retraction
feature, which will retract the Solar/Night Shade
to the full upper position in the rare event of an
internal motor failure.
Should the Automatic Safety Retraction
feature deploy, go to your nearest Winnebago
®
Industries dealer for service before operating
the shade again.
NOTE: Do NOT attempt to extend the Solar/
Night Shade or operate the power
switches after deployment.
Further Information
Refer to the manufacturer's user guide
provided in your InfoCase for complete operating
instructions, troubleshooting tips, and
maintenance care.

BRAKE-SHIFT INTERLOCK

®
Ford Chassis
The Brake-Shift Interlock is a safety feature
that prevents the shift lever from being moved
from the Park position unless the ignition is ON
and the service brake pedal is pressed.
NOTE: If the brake light fuse is blown, the
interlock feature will not work properly
and an alternate method must be used.