Checking Drive Belts; Checking And Replacing Fuses - Hyundai XG350 2005 Owner's Manual

G180A01A-AAT
CHECKING BRAKE PEDAL
CLEARANCE
2.95 in. (75 mm)
You need a helper to check the brake pedal
clearance. With the engine running, have your
helper press down on the brake pedal several
times and then hold it down with a force of about
110 lbs (50 kg, 490 N). The brake pedal clear-
ance is the distance from the top surface of the
brake pedal to the asphalt sheeting under the
floor mat.
If the brake pedal clearance is not within the
limits specified in the illustration, have it in-
spected by your Hyundai dealer and adjusted
or repaired if necessary.

CHECKING DRIVE BELTS

G190A01A-AAT
Power steering pulley
Crank shaft pulley
Drive belts should be checked periodically for
G180A01L proper tension and adjusted if necessary. At the
same time, belts should be examined for cracks,
wear, fraying or other evidence of deterioration
and replaced if necessary.
Belt routing should also be checked to be sure
there is no interference between the belts and
other parts of the engine. After a belt is replaced,
the new belt should be adjusted again after two
or three weeks to eliminate slack resulting from
initial stretching after use.
CHECKING AND REPLACING
FUSES
G200A01Y-GAT
Replacing a Fusible Link
Generator
A/C pulley
G140D02L
A fusible link will melt if the electrical circuits from
the battery are ever overloaded, thus prevent-
ing damage to the entire wiring harness. (This
could be caused by a short in the system
drawing too much current.) If this ever happens,
have a Hyundai dealer determine the cause,
repair the system and replace the fusible link.
The fusible links are located in a under hood
junction box for easy inspection.
6
DO-IT-YOURSELF MAINTENANCE
17
Bad
Good
G200A01L