Linkage Setup - HPI Racing Savage X 4.6 RTR Manual

2-6

Linkage Setup

Trim adjusts neutral position of servo.
Make adjustments with the engine off.
Steering Trim Setup
Turn steering trim to set tires in
completely centered position.
Throttle Linkage Setup
Turn throttle trim little by little and adjust rods as shown.
Important
No brake drag at neutral.
Optional Throttle Linkage Setup
Remove air filter to adjust throttle linkage. After setup is complete, reinstall the air filter. See Section 3-4.
Setting Full Throttle
Setting Full Brake
Steering trim
Throttle trim
3-4
Pull full throttle.
Make sure the carburetor is open.
Push trigger to the full brake position.
Try pushing the car to make sure the
brake works.
Brake Adjustment Dial
Less Braking
More Braking
Important
Make sure there is no brake drag at neutral.
Important
If throttle linkage is not set up correctly the car may lose control after
the engine is started.
Brake Adjustment Dial
11
Carburetor
Approximately
1mm (0.04")
Carburetor
Open
Carburetor
Approximately
1mm (0.04")
Adjustment
see section 2-9