Hpi Roto Start System Preparation - HPI Racing Savage X 4.6 RTR Manual

2-2

HPI Roto Start System Preparation

Roto Start makes engine starting easier. You must charge the battery before use.
Roto Start Details
Roto Start Unit
Starter Shaft
Roto Start Battery Charging
Only use charger designed for 7.2Volt battery pack.
Battery Installation
Starter Shaft
Switch
Switch Cover
Charger for Battery Pack 7.2 Volt
(Not included)
Battery Pack 7.2 Volt (Not included)
Roto Start Unit
Battery Lid
Circuit Breaker
If engine locks, the circuit breaker will stop the Roto
Start. Remove Roto Start and check engine for
flooding or damage. If there is no problem with the
engine, reset the circuit breaker by pushing the
button and try to start the engine again.
Caution
Do not use Nickel Cadmium battery charger for Nickel Metal
Hydride batteries. If you do not use the special charger for Nickel
Metal Hydride batteries, The batteries will be damaged.
After charging the battery, insert into Roto Start and connect the battery.
Then connect starter shaft.
Disconnect the battery when Roto Start is not being used.
Note Direction.
Battery Pack 7.2 Volt (Not included)
7
ON OFF